Kirby Avalir Not Picking Up

Important safety tips always make sure your machine is unplugged and the power button is turned off before servicing your vacuum.
Kirby avalir not picking up. However because of the many accessories it comes with the unit can be too complicated to operate in the different modes. Check the power cord for damage. Ht beam is not visible from the other end of the vacuum hose this indicates that the vacuum hose is clogged or obstructed.
Make sure the power cord is plugged into an outlet and that the outlet has power. If the nozzle is too high off the floor the brush will not reach the floor to clean it properly. If it is damaged have it replaced by an authorized kirby distributor.
Turn the shampoo system over again and while pressing the belt up with your finger use the handle on the belt lifter to turn it counterclockwise until the red arrows align. Kirby vacuum kirby avalir. Make sure the cord is fully inserted into the unit.
The vacuum might not be set at the proper height. The kirby avalir 2 is not difficult to assemble. It s convenient if you have to go up or down stairs or if you do not want to have to use the full vacuum all of the time.
To adjust the height simply press the toe touch pedal on the side of the unit. The belt lifter hook will catch and stretch the belt. Another reason may be because the brush roll is not turning.
At the same time it can also convert into a smaller handheld vacuum which can be operated with a single hand which makes the kirby avalir 2 ideal for small spot treatments and for picking up small messes. Slide the belt from the shampoo system over the center of the carpet brush roll and insert it into the shampoo system. Kirby vacuum not picking up.